10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 Boltek EFM-INV-M / EFM-INV2 / EFM-INV3 Inverting Mounting Kit Installation Instructions
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 DO NOT ALLOW FIELD MILL TO ROTATE OR WIRES CONNECTING FIELD MILL WILL TWIST COAT BOTH SIDE
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 ELECTROCUTION WARNING: INSTALLATION OF THIS PRODUCT NEAR POWERLINES IS DANGEROUS. FOR YOU
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 Contents of the Kit Your EFM-INV-M (Pole mount bracket), EFM-INV2 (2 foot tripod) or EFM-I
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 Choosing a Mounting Location Choosing a suitable mounting location is the single most impo
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 Assembling the pole mount bracket (Skip this page if using INV2 or INV3 kit) Remove nuts
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 Assembling the hardware EXPLODED VIEW OF ASSEMBLY COAT THREADS AND RUBBER WASHER WITH SILI
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 PIPE WRENCH TIGHTENING BULKHEAD ONTO MAST (HAND TIGHT +4 TURNS WITH WRENCH) COAT PIPE THR
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 EFM-INV2 USE 0.75X EFM-INV3 USE 0.5X INSTALL THE APPROPRIATE SENSITIVITY PLUG
10/10/2012 (C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2 COAT BOTH SIDES OF THE RUBBER WASHER WITH SILICONE GREASE Connect Power, Ground and Fiber
Kommentare zu diesen Handbüchern